Bond & Seal - Individual.

Our Lash Patisserie Bond & Seal is your go-to tool for applying and securing lash clusters. Designed to replace harsh salon glues, it’s latex-free and formulated without cyanoacrylate (super glue) or formaldehyde — so you can enjoy strong, flexible hold without compromising lash health.

On one end, the Bond features a fine micro-mascara wand for precise application at the lash roots, helping clusters grip in place quickly and cleanly. On the other end, the Seal offers a soft brush-and-dab tip, designed to remove tackiness and add a water-resistant layer that extends wear. Together, they make DIY lashes easier, safer, and longer-lasting.

⸻

Why You’ll Love It

• Strong yet flexible hold — no stiffness or crunch

• Black Bond blends naturally into the lash line

• Seal removes tackiness and adds a water-resistant finish

• Dual-ended, compact, and beginner-friendly

• Latex-free

• Free from cyanoacrylate and formaldehyde

Bond:
Acrylates Copolymer, Aqua, Cl 77266.

Sealant:
Aqua, Acrylates/Ethylhexyl Acrylate Copolymer, Propylene Glycol, Phenoxyethanol/Ethylhexyglycerin, Caprylyl Glycol, Octanol.

→ Clip your hair back to keep your face clear and avoid distractions during application.

→ Keep your fingers and tools clean – baby wipes or similar nearby really help

→ Apply bond only to the roots of your natural lashes – not like mascara

→ Wait 30 seconds for the bond to get tacky

→ Lay out your lash clusters beforehand so you’re not scrambling mid-application

→ Use tweezers to pick up each cluster by the very tip

→ After placing each one, wipe your tweezers clean and clamp down gently to secure so they don’t shift around

→ Once all clusters are placed, do a final press with clean tweezers

→ Then apply your sealant just at the base (not through the whole lash)

→ Apply Lash Patisserie Remover (or any gentle oil-based remover) to the base of your lashes where the bond sits

→ Wait 30–60 seconds for the remover to dissolve the bond

→ Slide clusters off gently with a cotton pad — no pulling or tugging

→ Brush through natural lashes with a clean lash brush

→ Wipe away any residue with a cotton pad before reapplying

→ Place clusters on a cotton pad

→ Apply remover and wait 30 seconds

→ Wipe away glue residue, repeating if needed until fully clean

→ Use a fresh cotton pad (dry or with micellar water) to wipe off any leftover remover/oil

→ Let clusters air dry fully before storing back in their tray

Always clean clusters after removal — this maximises reuse and keeps them fresh for next time.

→ Apply a small amount of product to a discreet area of skin (inner arm, bend of elbow, or behind ear)

→ Leave for 24 hours to check for any reaction

→ If irritation occurs, do not use 

Q: What is Bond & Seal used for?
It’s a two-step lash adhesive system—Bond secures the clusters, Seal locks them in for long wear.

Q: Is it beginner-friendly?
Yes! The dual-ended applicator makes it easy to control placement and finish.

Q: How long does it last?
With proper application and sealing, your lashes can last up to 5 days.

Q: Can I remove it easily?
Yes—use an oil-based remover or lash remover to gently dissolve the formula.

Q: Does it leave any residue?
No. The bond dries black, and the sealant doesn’t flake and dries clear.